United Kingdom · E5 battery electric · WLTP

Jaecoo EV Range Calculator

Plan the electric-only distance available within a JAECOO E5 charge window. The UK E5 reference is kept separate from JAECOO petrol and Super Hybrid models, whose combined fuel-and-battery range answers a different question.

Sources checked: . Published figures are comparison references; the adjusted result is your planning scenario.

Plan a charge window

Select your measured range to enter a vehicle-specific baseline. Published presets are locked to their cited values.

100% makes no adjustment. Enter a factor supported by your experience for weather, speed, load and route combined. This is your assumption; the tool does not predict those effects.

Estimated distance within your charge window

248.0 miles

399.1 km · no adjustment applied

Published baseline × your assumptions. This result is a planning scenario, not a new official range rating.

For the 248-mile first preset, leaving at 80% and reserving 10% makes 70% of the charge available: 173.6 miles before your conditions adjustment.

A 0% reserve is the mathematical full-range default. Set a practical arrival reserve before planning a trip, and follow the vehicle’s route and charging guidance.

Published configuration reference

Scroll the table horizontally on a small screen to see the rating and source.

Selected JAECOO range references
ConfigurationRangeTest cycle and source
JAECOO E5 Electric · UK Pure/Luxury specification248 miWLTP combined · up to · JAECOO UK E5 specification

The UK E5 specification table gives 248 miles WLTP for Pure and Luxury. JAECOO’s general FAQ says up to 249 miles; the calculator follows the model-specific table rather than averaging or inventing a new rating. The source is an up-to combined WLTP figure, not an EPA rating.

E5 Electric and Super Hybrid are different planning tasks

The JAECOO UK E5 specification table identifies Pure and Luxury electric variants at 248 miles WLTP. It lists 60.9 kWh battery capacity without a usable-versus-gross definition in that table, so this calculator does not treat that figure as independently verified usable energy. Its calculation uses range and charge percentage.

The general JAECOO FAQ quotes an E5 maximum of 249 miles. This page uses the model-specific 248-mile table and makes that source choice visible. Confirm the exact homologated figure for the specification you order.

Do not put a combined hybrid range into the E5 tool

A JAECOO 7 or 8 Super Hybrid figure can include both petrol and electricity. Scaling that combined distance by battery percentage would wrongly imply that all of the distance comes from charge alone. Use the electric-only range from the exact plug-in hybrid documentation with the PHEV calculator instead.

Make an E5 baseline from your own commute

Record the round-trip distance and charge percentage at departure and arrival on several comparable days. Include parking intervals, cabin use and the usual passenger load. Convert each trip to a full-charge equivalent, then enter a representative value under the owner option. A short, warm urban trip should not become the baseline for a cold motorway run.

If your measured baseline already represents your commute, leave the conditions factor at 100%. Change it only when you have a reason to explore another overall assumption. This page adds no fixed LFP, battery-age or heating multiplier.

Arrival planning before the next charge

Use a practical reserve and check the location, operating status and connector of the charging point you will depend on. A published full-charge WLTP figure does not tell you whether the charger will be available. The vehicle’s current range and route information can help you revise the plan while driving.

When comparing the E5 with another vehicle, use ratings from the same test cycle and the same type of driving information. Converting 248 miles to kilometres does not make it a different certified range test.

Calculation method and owner calibration

Distance = full-charge range × conditions factor ÷ 100 × (starting charge − arrival reserve) ÷ 100

The formula assumes distance scales approximately with usable state of charge. It models neither a charging curve nor changing wind, elevation, cabin energy or road conditions. The conditions factor is an explicit user assumption; it is not a validated model-specific weather forecast.

To create an owner baseline, divide a representative trip’s distance by the fraction of charge used. For example, 90 miles using 40 percentage points gives an approximate 225-mile full-charge equivalent. Repeat on comparable journeys. Small charge changes and rounded dashboard readings can make a single short trip misleading.

A 225-mile owner baseline, 80% conditions factor and 80% to 10% charge window gives 126.0 miles: 225 × 0.80 × 0.70. Keep the factor at 100% if the baseline already represents the journey, battery condition and load. This page applies no automatic battery-age penalty, heat-pump bonus or universal temperature multiplier.

Published presets are locked to their source values. Choose the owner option to enter your own full-charge range. The 0% reserve default only shows the complete mathematical baseline; set a practical reserve before planning a trip.

Questions JAECOO owners ask

Which JAECOO range does this calculator use?

The UK E5 Electric Pure/Luxury specification table gives up to 248 miles WLTP. A generic FAQ quotes 249; this page follows the model-specific table.

Can I enter a JAECOO Super Hybrid combined range?

No. Combined petrol-and-electric range cannot be scaled by battery charge alone. Use the exact electric-only PHEV range for a plug-in hybrid.

Does the tool estimate battery health from vehicle age?

No. An owner-provided range can reflect the current vehicle, but age alone is not a battery-health measurement and receives no automatic deduction.

Continue planning

EVRatio is an independent planning website. A comparison rating and a scenario estimate cannot promise the distance your car will travel.